Link to Fix PSA 1000-0213PSA+ 2000-0213 The CMOS battery failed Link to Fix PSA 1000-0214 Failure in DMA %s Port: XXh. If the computer boots, add the peripheral cards back one by one until you find the bad one. Windows Vista: Click Start ® Control Panel® Hardware and Sound® Scanners and Cameras. When the computer starts normally, the lights flash, and then turn off. http://applecountry.net/dell-optiplex/dell-optiplex-755-boot-error-codes.php
Parameters Allows you to customize the test by changing the test settings. ABCD CPU Disconnect all external peripherals and configure PC down to PSU, Motherboard and CPU If fault continues contact your technical support If fault stops, plug disconnected parts back one at MEMORY WRITE/READ FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE A memory module may be faulty or improperly seated. Keyboard controller test failure. http://www.dell.com/support/article/us/en/04/SLN284978/en
The device is not ready The drive cannot read the disk. Contact Us PSA 1000-0221PSA+ 2000-0221 Interval Timer Channel 0 (mode 0) is not generating interrupts Link to Fix PSA 1000-0222 Interval Timer Channel 0 (mode 3) is generating the wrong interrupt MEMORY ODD/EVEN LOGIC FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE A memory module may be faulty or improperly seated.
The light remains solid or off to indicate different states: No light Indicates no power available for the power supply or the power supply is not working.Green light Indicates The message is most likely to occur after a memory module is installed. If the problem persists, contact Dell. Dell Optiplex Gx520 Error Codes NOTE: If you are using an ultra form factor computer, the diagnostic lights are present on the back panel.
Uw feedback is verzonden. Dell Optiplex Gx270 Error Codes The Dell Diagnostics obtains configuration information for all devices from System Setup, memory, and various internal tests, and displays the information in the device list in the left pane of the Be sure to remove and reinstall the cables for the hard drive if you are on a Desktop Computer. have a peek at these guys Remove the coin cell battery for one minute, reinstall the battery, and restart.
Run the System Set tests in the Dell Diagnostics TIME-OF-DAY CLOCK LOST POWER System configuration settings are corrupted. Dell Optiplex Error Codes 1 3 Contact Dell Technical Support. BIOS Chip System board failure, covers BIOS corruption or ROM error 2 No RAM Detected No memory detected 3 Chipset Error (North and South Bridge Chipset, DMA/IMR/Timer Error for Intel platform); For additional safety best practices information, see the Regulatory Compliance Homepage on www.dell.com at www.dell.com/regulatory_compliance.
Then, shut down the computer, reinstall the hard drive, and restart the computer. http://www.dell.com/support/article/us/en/04/SLN284898/en If available, install working memory of the same type into your computer. Dell Optiplex 755 Error Codes If there is an error message on the screen identifying a problem with a device (such as the hard drive), check the device to make sure it is functioning properly. Dell Optiplex Gx280 Error Codes Non-system disk or disk error The floppy disk in drive A does not have a bootable operating system installed on it.
Installing 3 Hard Drives in a Dell XPS 8300 is Absolutely Possible (and easily done) Intel Chipset & Realtek HD Audio update & simple check Optiplex USFF, DVI, Dual Monitors and http://applecountry.net/dell-optiplex/dell-optiplex-330-error-codes-1-3.php Only part of the display is readable Connect an external monitor Shut down your computer and connect an external monitor to the computer. No timer tick interrupt A chip on the system board might be malfunctioning or motherboard failure (see Contacting Dell for assistance). Shut down the computer, remove the hard drive, and boot the computer from a CD. Dell Optiplex Gx620 Error Codes
Restart the computer. Not enough memory or resources. Use the up- and down-arrow keys to select Diagnostics from the boot menu and then press
If the computer starts normally, continue to install additional memory modules (one at a time) until you have identified a faulty module or reinstalled all modules without error. Dell Optiplex 755 Error Codes 2 And 4 Take the appropriate action. NOTE: If you see a message stating that no diagnostics utility partition has been found, run the Dell Diagnostics from your Drivers and Utilities media (see Starting the Dell Diagnostics From
If the error message is not listed, see the documentation for the operating system or the program that was running when the message appeared. Press and hold the power supply test button on the back of the power supply unit. Hard-disk drive read failure The hard drive failed initialization. Dell Optiplex 960 Error Codes If the problem persists, try another drive.
If the LEDs never came on at any point then look into a power issue. Windows XP: Click Start > Control Panel > Add or Remove Programs > Programs and Features. Run the System Memory tests and the Keyboard Controller test in the Dell Diagnostics. http://applecountry.net/dell-optiplex/dell-optiplex-error-codes-1-3.php If the LED still does not illuminate, the problem is probably with the power supply.
If the power light is steady amber A device may be malfunctioning or incorrectly installed. Click the Applications tab. Power off computer, leaving the computer plugged in. Ensure that the volume is turned up and that the sound is not muted.
Diagnostic LEDs for the OptiPlex series (2005 to 2009) This series had a combination of Power button LED states and the A, B, C, B, block was replaced with 1, 2,