Unsupported Message Rcvd; Transaction Failed Base Diameter 0 3002 DIAMETER_UNABLE_TO_DELIVER Message can not be delivered to the destination, because no host within the realm supporting the required application was available to Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc., a non-profit organization. Standards Track [Page 28] RFC 3588 Diameter Based Protocol September 2003 +------+ | | | DRD | | | +------+ ^ | 2. However, since RADIUS does not provide explicit support for proxies, and lacks auditability and transmission-level security features, RADIUS- based roaming is vulnerable to attack from external parties as well as susceptible check over here
These applications are introduced in this document but specified elsewhere. The request’s state is released upon receipt of the answer. Security policies, which are not the subject of standardization, may be applied by next hop Diameter peer or by destination realm. answered Apr 7, 2014 by Bart Barton Thanks for your answer. http://diameter-protocol.blogspot.com/2012/10/list-of-result-codes.html
One such AVP may be present in an authentication or authorization request or response. Includes Juniper-Logical-System and Juniper-Routing-InstanceGrouped2050Juniper-Request-TypeJSRC, PTSPDescribes the type of request:1—ADDRESS_AUTHORIZATION2—PROVISIONING_REQUEST3—SYNCHRONIZATIONEnumerated2051Juniper-Synchronization-TypeJSRC, PTSPDescribes the type of synchronization:1—FULL-SYNC2—FAST-SYNC3—NO-STATE-TO-SYNCEnumerated2052Juniper-SynchronizationJSRC, PTSPDescribes the state of synchronization:1—NO-SYNC; this is the default state2—SYNC-IN-PROGRESS3—SYNC-COMPLETEEnumerated2053Juniper-Acct-RecordJSRC, PTSPSpecifies the statistics data for each policy Transaction Failed SLg 3GPP (10415) 4226 DIAMETER_ERROR_UNKNOWN_UNREACHABLE LCS_CLIENT Sent by the GMLC to indicate that the LCS Client was not known or could not be reached.
DIAMETER_USER_UNKNOWN 5030 ECE was not able to locate the subscriber ID in the diameter request. The message is forwarded by the NAS to its relay, DRL, which does not have a routing entry in its Diameter Routing Table for example.com. The new AVP being defined MUST use one of the data types listed in Section 4.2. Diameter Error Code 4010 StatusT This is the state of the peer entry, and MUST match one of the values listed in Section 5.6.
Transaction Failed SLg,T6a/T6b 3GPP (10415) 4222 DIAMETER_ERROR_SUSPENDED_USER Sent by the MME to indicate that the user is suspended in the MME. 5012 Diameter Error Code Relays modify Diameter messages by inserting and removing routing information, but do not modify any other portion of a message. NAPTR Example....................................... 142 Appendix C. http://www.ibm.com/support/knowledgecenter/SS2P3U_6.1.0/com.ibm.diameter.dev.doc/diameter_result_codes_r.html September 2003 RFC 6733 RFC 3589 Diameter Command Codes for Third Generation Partnership Project (3GPP) Release 5.
Accounting-Sub-Session-Id AVP................ 123 9.8.7. 5004 Diameter Error Code I would say If the receiver of the CER is unable to comply with what is in the request (different capabilities), it should send a CEA with the Result-Code AVP set Diameter Command Naming Conventions................... 38 4. App ID Result Code Name Description dsTest® OM Reference Point 1XXX Informational 0 1001 DIAMETER_MULTI_ROUND_AUTH Informs sender that the authentication mechanism being used requires multiple round trips, and a subsequent requests
A Command Code is used to determine the action that is to be taken for a particular message. i thought about this See Section 6.1.7 for redirect guidelines. Diameter Error Code 5030 Standards Track [Page 16] RFC 3588 Diameter Based Protocol September 2003 Real-time Accounting Real-time accounting involves the processing of information on resource usage within a defined time window. Diameter Error Code 3002 Category: Standards Track J.
Peer State Machine.................................... 66 5.6.1. http://applecountry.net/error-code/diameter-3010-error-code.php Disconnect-Peer-Answer....................... 63 5.4.3. This is typically accomplished by tracking the state of NAS devices. A Realm Routing Table Entry contains the following fields: Realm Name This is the field that is typically used as a primary key in the routing table lookups. Diameter Error Code 4012
Translation agents are likely to be used as aggregation servers to communicate with a Diameter infrastructure, while allowing for the embedded systems to be migrated at a slower pace. Table D-3 Transient-Failure Result Codes Result Code Code Notes DIAMETER_END_USER_SERVICE_DENIED 4010 The rating function failed with one of the following errors: MISSING_SYSTEM_ALTERATION_FOR_DEBIT INCORRECT_IMPACTS_FOR_DEBIT & LIFECYCLE_VALIDATION_FAILED Check the ecs.log file for the If not, how will PCRF know that there might not be any congestion now?ReplyDeleteD3viLFebruary 19, 2015 at 3:58 AMhey folks, all this codes are described in RFC and 3Gpp. this content Session A session is a related progression of events devoted to a particular activity.
If the base accounting is used without any mandatory AVPs, new commands or additional mechanisms (e.g., application defined state machine), then the base protocol defined standard accounting application Id (Section 2.4) Error Code 2001 Iphone 4 Transaction Failed Gx 3GPP (10415) 5145 DIAMETER_QOS_RULE_EVENT Used when the QoS rules cannot be installed/activated. Transaction Failed Sh/Dh 3GPP (10415) 5106 DIAMETER_ERROR_SUBS_DATA_ABSENT AS requested to subscribe to changes to Repository Data that is not present in the HSS.
If no messages have been exchanged for some time either side may send a Device-Watchdog-Request (DWR) and the other peer must respond with Device-Watchdog-Answer. Some common Diameter commands defined in the protocol (base and applications) are: Command-Name Abbr. Includes Tekelec-Charging-Rule-Argument-Name AVP (5555) and Tekelec-Charging-Rule-Argument-Value AVP (5556).Grouped5558Tekelec-Charging-Rule-With-ArgumentsGx-PlusRequests the installation of the rule (activation of the service) designated by the included Charging-Rule-Name AVP (1005). Error Code 2001 Itunes When to set Error 'E' bit in Diameter message?
Transaction Failed Rx 3GPP (10415) 5065 IP-CAN_SESSION_NOT_AVAILABLE PCRF rejects a new Rx session setup when it fails to associate the described service IP flows within the session information received from the In the event that a logical grouping of AVPs is necessary, and multiple "groups" are possible in a given command, it is recommended that a Grouped AVP be used (see Section Diameter Protocol..................................... 9 1.1.1. http://applecountry.net/error-code/diameter-error-code-4010.php Standards Track [Page 29] RFC 3588 Diameter Based Protocol September 2003 2.9.
I am not able to understand about transient failure category. +1 vote Diameter Result code 4999, can anyone tell me the implementation made/seen for this result code. +1 vote When to Since Relays do not perform any application level processing, they provide relaying services for all Diameter applications, and therefore MUST advertise the Relay Application Identifier. 2.8.2. Peer Connections...................................... 56 5.2. PROPOSED STANDARD.
Anti-spam verification: [captcha placeholder] To avoid this verification in future, please log in or register. A stateless agent is one that only maintains transaction state. For a static interface, the value is the interface name, which is used as the subscriber’s login name.UTF8String2User-PasswordNASREQSpecifies the password of the user to be authenticated or the user's input in Proxy-State AVP.............................. 79 6.8.
All Diameter packets with the same Session-Identifier are considered to be part of the same session. This requires that proxies maintain the state of their downstream peers (e.g., access devices) to enforce resource usage, provide admission control, and provisioning. QUERY HOME 2016 © Queryhome ...